Filter Results By:
Products
Applications
Manufacturers
Base Station
Radio receiver / transmitter serving as the hub.
- InterWorking Labs, Inc.
product
Remote Monitor Management Information Base
SNMP RMON MIB
For every control table in the MIB, create and delete rows with various combinations of SNMP requests (all variables in a single request throughall variables in individual requests).Determine which row of this table is modeling the ethernet interface connected to the agent (requires that we are using ethernet). Check that this is for the same interface discovered in the "interfaces" test. Check counters.Build a history control row pointing to the interface connected to the agent. Check validity and traffic reported.Test agent's ability to generate an alarm on an RMON variable, then on threshold condition. Test for support of alarms on failing events, and in the event of target variable vanishing.Set up agent to track hosts on the ethernet interface connected to the agent. Check that entry was added for Rmon device's own ethernet address.Generate various top N reports (hostTopN test) and check validity.Start a matrix capture and check that the src-dst and dst-src tables are in sync.Check a channel and check for event generation (filter test).Create a channel and start a capture. Test locking and wrapWhenFull operation.
-
product
LMR Signal Boosters
When a direct base station connection is not available, an alternative is to amplify a low level signal off the air into a building or other disadvantaged location. Once amplified, the signals can be used to drive a passive coax and antenna system.
-
product
Weather Detection Systems
General offers weather detection systems that use a base station to display inputs received wirelessly from remote sensors. The RGR150 can track rainfall amounts as well as temperature and/or relative humidity. WS821 & WS831DL Weather Detection Systems are full-featured wireless weather stations that add wind speed readings and track trends in barometric pressure that can serve as the basis of a short-term weather forecast. Barometric pressure is also available from a dedicated wireless station (the DBAR880), and the original weather forecasterthe ABAR300 Analog Barometer.
-
product
802.11n wireless access point
SX-AP-4800AN2
SX-AP-4800AN2 is a dual band 802.11n wireless access point (base station) and is able to communicate with station devices (clients) supporting IEEE802.11a/b/g/n wireless networks. SX-AP-4800AN2 is ideal for business and factory environments supporting enterprise wireless security and PoE (Power over Ethernet).
-
product
SparkFun GPS-RTK-SMA Breakout
ZED-F9P (Qwiic)
Based on the SparkFun GPS-RTK2 designs, the SparkFun GPS-RTK-SMA raises the bar for high-precision GPS and is the latest in a line of powerful RTK boards featuring the ZED-F9P module from u-blox. The ZED-F9P is a top-of-the-line module for high accuracy GNSS and GPS location solutions including RTK that is capable of 10mm, three-dimensional accuracy. With this board, you will be able to know where your (or any object's) X, Y, and Z location is within roughly the width of your fingernail! The ZED-F9P is unique in that it is capable of both rover and base station operations. Utilizing our handy Qwiic system, no soldering is required to connect it to the rest of your system. However, we still have broken out 0.1"-spaced pins in case you prefer to use a breadboard.
-
product
Wireless Network Optimization Solution
It is a solution that collects and analyzes the radio wave environment and transmission/reception data between the base station and the terminal in real time to improve the quality of communication services, and provides various solutions such as vehicle measurement, walking measurement, and telemetry.
-
product
Land Mobile Radio
Land Mobile Radio systems are commonly used for critical communications by public safety organizations such as police, firefighters, and other emergency response organizations. In addition to the public safety sector, LMR systems are also commonly used in the commercial world in various industries including industrial, transportation, utilities, security, and logistics. LMR systems typically consist of handheld portable radios, vehicle mounted mobile radios, fixed base stations and repeaters, and network infrastructure.
-
product
Femtocell and Application Testing
About the size of a home ADSL Router, a Femtocell (also known as an Access Point Base Station) is designed to allow 3G enabled devices (Phones, PDAs, Laptops) to connect to a carrier's core 3G network even where the carrier does not provide a signal themselves. It does this by bridging between the Wireless 3G devices and the carrier’s network using the Internet. Specifically, it will be connected to a Router (ADSL, Cable or other) already providing access to the Internet. Calls made and data services used on the 3G device are then sent to the carrier (and received from the carrier) over IP.
-
product
RF Tower Top Amplifiers and Receiver Multicouplers
Tower-Top Amplifiers (TTA) are high performance, quadrature-coupled low noise amplifiers (LNA) designed to increase the performance of a Base Transceiver Station (BTS) while ensuring reliable communications for critical Public Safety applications.
-
product
RxAIT
*RxAIT includes a Receive Multi-coupler (RMC) with a series of duplexers and Low Loss Combiners (LLC)*Provides the ideal ground based antenna sharing solution and reduces feeder line count and tower loading*Provides a common receive distribution point for multiple base stations*Each cellular and PCS unit supplies 8 ports and supports 2 channels
-
product
GNSS Modular Receiver
R750
Save time, money and headaches with the Trimble R750 GNSS Modular Receiver, Trimble's reliable, easy-to-use base station solution. With remote monitoring and alerts, an internal radio, LTE modem and rover capability, the R750 is designed to meet all your needs.
-
product
Bi-Phase Modulators
PMI's line of Bi-Phase Modulators includes a comprehensive selection of different models which cover broad octave frequency bands ranging from 0.5 to 40 GHz. Bi-phase modulators take a TTL level digital bits stream that’s encoded onto the RF carrier using 2 Phase Shift Keying (2PSK) modulation, where the 2 phases are separated by 180º. This performance is desirable in communications systems, microwave radio, radar, high data rate test & measurement, serial data transmission, base station infrastructure, and other industrial and military applications.
-
product
Frequency Counter with Rubidium Timebase
SR625
Stanford Research Systems, Inc.
The SR625 Frequency Counter is a NIST traceable frequency counting standard for calibarating base stations, transmitters and many other types of communication systems.
-
product
Autosamplers for Chromatography
Maximize the throughput and flexibility of your ACCQPrep system by adding automated sample loading for longer unattended operation.The two rack AS 2x2 and four rack AS 4x2 sampler options allow different chromatographic conditions to be applied to a variety of different samples and doubles or triples the fraction collection capabilities of the base system.The ACCQPrep AutoSamplers provide high recovery of samples with 99.9% transfer of analyte. PeakTrak software allows users to quickly create sample queues for walk up open-access labs and overnight purifications. Develop methods that result in the highest purity and largest loading capacity with the 3 Step Focused Gradient Generator that works seamlessly with the AutoSampler and PeakTrak software. An integrated wash station and sophisticated robotic probe movement ensures sample purity and limits cross contamination.
-
product
RF Matrix Switch for Wireless Technologies up to 4 GHz
NEXUS-4
Quintech Electronics and Communications Inc.
The NEXUS-4 is a bi-directional fully non-blocking 3232 RF matrix switching system that can route any input ports to any outputs in a 6 RU chassis. With the frequency range of 700 MHz to 4 GHz and the capability of expanding to 256256, it enables large scale wireless testing that involves many MIMO base stations and devices. The built-in programmable attenuators and efficient automation interface provide ease-of-use testing of signal fade and emulation of mobility scenarios. It can dramatically increase lab efficiency by eliminating manual patch panel and cabling as it can be remotely reconfigured for different test setups consistently in seconds.
-
product
Plane Wave Converter
PWC200
The R&S®PWC200 Plane Wave Converter is a bidirectional array of 156 wideband Vivaldi antennas placed in the radiating near field of the device under test (DUT). The phased antenna array can form planar waves inside a specified quiet zone within the radiating near field of the 5G massive MIMO base station for realtime radiated power and transceiver measurements (EVM, ACLR, SEM, etc.).
-
product
Off-Line Base Test Platforms
To configure your Base Test Platform, the following parts can be added to the 6TL-19 bare half-rack:– Test Rack Manager, to control the test station.– Power Distribution Unit.– Uninterruptible Power Supply– Industrial PC or NI PXI to control the platform– 19’’ Monitor and keyboard with trackball– VPC Mass Interconnect Receiver (6 or 12 slots)– YAV Modules– Accessories: Beacon, Air inlet Pneumatic kit…– Any 19’ Instrument
-
product
BDAs & Repeaters
*Bi-directional amplifiers designed for Nano, Pico and Femto base stations*The PCS and AWS configurations provide up to 10 dB of Uplink and 25 dB Downlink gain*Separate TX and RX inputs and a common antenna port with an optional full duplex input*Ideal for in-building and spot coverage applications
-
product
PEM Fuel Cell
48 Volt 5kW
It is the aim of CellCare Technologies to continually introduce new technology that can provide significant benefits over existing solutions in specific applications. Fuel cellThe latest introduction to the product portfolio is a 5kW PEM (Proton Exchange Membrane) based hydrogen fuel cell, designed to replace 48V standby batteries within remote telecoms sites, satellite base stations, ISP base stations, uplink facilities and weather data collection sites. This technology provides instant power with no hazardous waste, zero emissions, extended autonomy and a guaranteed lifetime with minimal maintenance.
-
product
M2M & IoT Installation Tools
Berkeley Varitronics Systems, Inc.
Handheld installation receivers for realtime 3G and 4G RSSI and RSRP signal strength of nearby wireless carrier base stations for M2M & IoT site surveys and antenna alignment for smart meters, EV charging stations, vending machines, wireless kiosks, digital signage, ATMs and more.
-
product
Active Type Hydrogen Frequency
CH1-1003M
Hydrogen frequency and time standard Ch1-1003M is designed for precision storage and reproduction of the size of frequency and time units as part of measures and reference complexes. Main applications: – national time and frequency services; – ground stations for tracking and control of satellite radio navigation systems; – radio interferometry with extra long base.
-
product
Precision Conical Dipole
PCD 8250
Exposure evaluation next to mobile communication facilities e.g. GSM and UMTS base stations. Accurate RF radiation safety measurements e.g. nearby broadcast stations or in buildings. All kinds of field strength measurements where high precision, a wide frequency range and small antenna dimensions are required. Measurements according to our Field Nose method. Frequency range: 80 MHz 3 GHz
-
product
Coaxial Components
Surge arrestors are designed to protect wireless base stations, switching centers and transmission lines fromthe damaging effects of extreme high voltage surges caused by lightning strikes. The RFS lightning protectiondevices are designed and tested to the most demanding specifications. They are rated to protect against bothdirect and indirect multiple strikes in the harshest environments imaginable. Their rugged construction utilizes solid metal housing, and superior plating, which results in outstanding system protection and operatingcontinuity.
-
product
Base Station Emulator
SUTP 5018
Designed to create a custom cellular environment to serve testing and characterization needs. The combination of high power, real-time computing and the software defined radio platform enables this instrument to create your own cells for testing in a compact size and cost-efficient way.
-
product
Attenuation Control Unit, DC to 18 GHz, 0 to 121 dB, 1-dB Steps
J7201B
Designed for WLAN and WiMAX™ device manufacturing test and mobile handset base transceiver station (BTS) handover test.
-
product
Wireless
Radio Talkback
The 430-00-XX is a rugged, full duplex UHF base station ideally suited to any application within TV studio, OB/SNG and theatre environments where clear and dependable wireless communication is critical. Both single and dual antenna versions are available covering the 440-470MHz band, each with 32 channels and programmable RF power level from 10 to 50 Watt.
-
product
Indoor DAS Transmitters
Berkeley Varitronics Systems, Inc.
Lightweight DAS transmitters and high-speed receivers for the build-out, optimization and indoor coverage studies of in-building microcell networks and base station repeaters.
-
product
Interconnect Products
Typical industrial applications for Oxley Interconnect products include high voltage power supplies, critical computer hard drives, fire safety control equipment, medical and pharmaceutical equipment, oil and gas control systems, power generation and distribution equipment, rail and telecommunications infrastructure. Within aerospace and military markets Oxley products are typically found in aircraft, military vehicles, ground base stations, surface ships and submarines and air and ground communications equipment.
-
product
Probing Solutions
ES62X-CMPS
The ES62X-CMPS compact manual probe station is a rugged wafer probing solution designed for high reliability, compact size and low investment cost. It enables manual wafer level measurements up to 300 mm wafers. The probing station can also be used for TLP, HMM, HBM, LV-Surge, RF, S-parameter and DC-measurements. Micro positioners with vacuum as well as magnetic base can be attached. The chuck has a vacuum interface for the wafer and is electrically isolated. Multiple 4 mm connectors can be used to connect a voltage potential to the wafer backside.
-
product
Multi-Layer Analyzers
LTE-Advanced Xpert™
The LTE-Advanced Xpert multi-layer analyzer is a unique, real-time continuous protocol analyzer for LTE and LTE-Advanced networks. Installed between a base station and its served mobile devices, the LTE-Advanced Xpert captures the LTE-Uu uplink and downlink transmission and performs deciphering and analysis of data and control channels in real time.
-
product
Terminal Power Meter
TPM-50A
ShinewayTech@ TPM-50A Terminal Power meter can test (1) Average power range: -40 dBm~+20 dBm；(3) Modulation bandwidth: 5MHz；(3) Continuous signal and burst signal test. Highly accurate power measurement CW and digital modulated signal (For example: GSM/EDGE, CDMA/EV-DO, WCDMA/HSDPA, WiMAX, and TD-SCDMA). It is very important to test that if the transmitter is at a specified level or not. For example, the tester needs to test the output power of base station. Because the lower output power produces the larger coverage area to cause call interruption.
