Filter Results By:
Products
Applications
Manufacturers
Water
llquid state of H2O. AKA: H2O
See Also: Water Quality, Water Meters, H2O, Wastewater, Underwater, Water Spray, Water Leak, Water Flow, Sea, Subsea, ADCP, Hydrogen, Oxygen, River, Ocean, Farm, Aquarium, ICE
- Taylor Dynamometer, Inc.
product
1100 HP Water Brake Chassis Dynamometer
CM-51
AC power, air and water required at one side wallas applicable.• Room length, and pit location within length,must be determined by user to fit maximumtruck length and rear overhang.• Provide at least one man door for fire escapenear rear of room, but not in rear wall becausesomeone entering during a test could be struckby a stone flung from a tire. Provide ample fireextinguishers at each door and near driver.• “Back-on, Drive-off” installation configurationpreferred.
-
product
Conductivity and Temperature Water Pocket Meter
LAQUAtwin EC-22
The only pocket meter that directly measures conductivity in 0.12ml sample. No need for a beaker to calibrate your meter or measure a sample. Just place few drops of the standard or sample onto the sensor. This procedure saves you time and prevents wasting your precious sample.
-
product
Portable Water Pressure Recorder
FJN-501
Completely water proof air sealed mechanism. Recording can be observed through the round window when the cover is closed. Compact, sturdy construction for easy portability. Durable, designed to hold up under hard use and with-stand corrosion.
-
product
Rain Test Chamber
Wewon Environmental Chambers Co, Ltd.
Water pump for rain test chambers uses highly pressure stainless steel pump, ensure water pressure and flow of the test cycle, the pump is installed in the side of the IP test device, and both ends of the inlet and outlet to set up the joint, easy to replace and repair. Water tank can be disassembled,The corresponding joint or hose connection is arranged in the water pipe connection.
-
product
Oxygen Logger Sensor
NUL-205
This sensor can be used to make measurements of the level of free oxygen in air or dissolved oxygen in water. The free oxygen in air mode is used to measure changes in oxygen levels during combustion or in reactions that produce oxygen (hydrogen peroxide decomposition). The dissolved and free oxygen modes are very useful in the study of photosynthesis.
-
product
Multiparameter Analyzers
Multi-parameter analyzers can be used in processes such as wastewater treatment, drinking water supply and is necessary to support life and treatment developments. In addition, the meter can be used in research institutions, and at a variety water quality related production sites in the mining, agriculture, forestry and fishery industries, for measuring the ionic concentration and various laboratories for the researches, drug manufacture processes, agriculture to measure the salinity levels of surface water and of soil samples, environmental protection, cosmetic industry food processing
-
product
Handheld Water Quality Meters
LAQUA EC220
Waterproof standard handheld meters with backlit LCD, shockproof & scratch-resistant non-slip casing, built-in electrode stand, and foldable meter stand in durable carrying case for routine water quality testing in the field.
-
product
Process Analyzers
202X Series – single-method process analyzers
Single-method process analyzers for water and wastewater monitoring with titration, pH, ISE, or photometry methods.
-
product
Portable Water in Oil and Dewpoint Analyzer
DOMINO USS
The Doble DOMINO USS (Ultimate Sampling System) gives you a fast, efficient way to measure water content in oil and/or the dewpoint of a gas.
-
product
Panel-mount Type pH Meter (Four-Wire Transmission, Industrial Time sharing Proportional Control)
HP-480TP
HP-480 connects pH sensor and measures pH and temperature in the sample water. Suitable for monitoring and control of various production processes and wastewater treatment, etc. Many types of electrodes are available to match the sample properties.HP-480TP is a pH meter with a time sharing proportional control function, making it ideal for tasks such as interval processing in any type of control process.
-
product
Turbidity Sensors
Turbidity sensors measure the amount of light that is scattered by the suspended solids in water. As the amount of total suspended solids (TSS) in water increases, the water's turbidity level (and cloudiness or haziness) increases. Turbidity sensors are used in river and stream gaging, wastewater and effluent measurements, control instrumentation for settling ponds, sediment transport research, and laboratory measurements.
-
product
Chemical Oxygen Demand (COD) Analyzer
PeCOD®
MANTECH’s revolutionary PeCOD® Analyzer technology provides accurate chemical oxygen demand (COD) results in 15 minutes — without the use of harmful chemicals including dichromate and mercury. Highly adaptable for wastewater and drinking water applications, the PeCOD® Analyzer’s patented nanotechnology-based approach to COD analysis will save you time and money while protecting the environment and the health and safety of your workers.
-
product
Density & Specific Gravity
To maintain consistency of a coating, the Density should remain constant from batch to batch. Density Cups, also known as Specific Gravity Cups or Picnometers, are used to determine the mass per unit volume (Specific Gravity) of a liquid at a given temperature. Specific Gravity is defined as the ratio of the density of a given substance to the density of water, when both are at the same temperature. As the Specific Gravity Cup is an exact measurement of the volume of the liquid, it is imperative that the exact weight of the sample is obtained.
-
product
Water Separability Tester
K676
Chongqing Kailian Yongrun Industrial Co.,Ltd.
It is designed to determine the water separability of petroleum and synthetic fluids.Conforms to GB/T 7605, GB/T 7305 and ASTM D1401.
-
product
Nitrate Logger Sensor
NUL-241
The NeuLog nitrate sensor can be used to measure the concentration of nitrate ions (NO3-) in aqueous samples.Nitrates are used in fertilizers and can contaminate water. Also, untreated human sewage can be a source of nitrate contamination.Nitrate measurements can also be very relevant to study the nitrogen cycle in general and to relate this cycle to plants and algae.
-
product
Pipeline & Cable Locator
Fuji Pipe & Cable locator assists you with its high performance on the engineering work site in locating the underground utilities such as the Metallic Water lines, Gas lines, tracer wire by plastic pipe, telephone/TV cables, copper and aluminum wire, conduit and power lines. This is the result of an evolution from the original FUJI TECOM Pipe & Cable Locator manufactured in 1967.The Differential antenna, which minimizes the influences of inductive fields and thus facilitates the accurate location of utility lines.
-
product
IEC60529 IPX34 Hand Held Spray Nozzle
IPX34
Shenzhen Chuangxin Instruments Co., Ltd.
The Spray Tester IPX 3/4 is a hand-held test device to verify protection against spraying and splashing water. The water pressure can be adjusted using the flow control knob on the device to give the required flow rate.
-
-
product
Water Monitoring Modules
Unidata offers a wide range of instruments to suit the measurement of conductivity, evaporation, water depth and temperature. In addition to those water instruments, Unidata also offers Starflow QSD ultrasonic Doppler velocity and depth SDI-12 Instrument.
-
product
Wave Profiler
The Wave Profiler allows the user to measure non-directional wave parameters continuously for long periods of time with high temporal and spatial resolution in deeper water from the safety of an underwater mooring. The instrument is particularly useful for clients who need to measure long-period waves (such as rogue waves or infra-gravity waves), waves in wash and in wakes, and non-linear waves.
-
product
Oil in Water Analyzers
Teledyne Analytical Instruments
Oil in Water Analyzers by Teledyne Analytical Instruments
-
product
Portable Density/Specific Gravity Meter
DA-130N
Measuring method Natural Oscillation typeMeasurement object Liquid sample test materialsRange 0.0000 ~ 2.0000 g/cm3Precision 0.001 g/cm3Resolution 0.0001 g/cm3Temperature range 0 ~ 40.0CTemperature compensation Up to 10 entries for temperature compensation coefficient and converted temperatureAutomatic calibration All density values of pure water needed for auto calibration can be stored.Number of data 1,100 samplesExternal outputPC or Printer can be connected. (not both) IrDA interface is standard equipped. Connection via RS-232C requires optional infrared RS converter (98-029-0007).
-
product
pH Meter pen type
pH 703
High quality, light weight and compact design. Measure water pH fast and easily in many fields such as swimming pools, aquariums, cooling towers, water and wastewater treatments, sanitation plants and laboratory applications. High resolution 0.01pH and high accuracy +/- 0.02pH. Comes complete with protective carry case and standard pH7 buffer solution
-
product
Clora Online
Chlorine is often present in crude oils and the concentration can vary greatly depending on the origin. If not removed, Chlorine can react to form highly corrosive hydrochloric acid in areas such as crude tower overheads, leading to serious operational issues, economic loss and safety concerns. The need for a reliable online chlorine analyzer for refining process control is more important than ever. Clora Online complies with ASTM D7536 method, and delivers continuous chlorine analysis to monitor plant equipment corrosion. By monitoring desalted crude, a plant can optimize performance and immediately see impacts of crude changes (including organic chloride). Additionally, monitoring overhead water can provide the necessary feedback for chemical feed.
-
product
N2O/H2O Trace Gas Analyzer
LI-7820
The LI-7820 N2O/H2O Trace Gas Analyzer offers high-precision nitrous oxide measurements in a low power, portable design—enabling it to easily integrate into survey and long-term soil flux systems. Pair it with the LI-7810 CH4/CO2/H2O Trace Gas Analyzer or LI-870 CO2/H2O Analyzer for CO2 and CH4 measurements at your site.
-
product
Oxygen Meters
In the diverse PCE range you will find an oxygen meter for water and gases. We have available an oxygen meter for water for both pure oxygen content and for oxygen concentration. The oxygen meter for water and gases has a water resistant design, interface and internal data memory as well as the classical version for laboratories. The oxygen meter for gases follows the security norms and is used for detection and measurement of methane, hydrogen sulfide, carbon monoxide and oxygen (as well as 50 more gases).
-
product
Flow Meters for Water
*With volumetric flow quantity, total quantity and temperature indication*High accuracy, repeatability and measurement dynamics*With switching output, analog output and pulse output*Clearly visible LED display
-
product
Water Quality Transmitters
Omga's Water Quality Transmitters are multi-variable loop powered transmitters that can be configured for use with pH, ORP, Conductivity, or Flow sensors and can be wall, pipe, or pannel mounted
-
product
Auto Water Vapour Permeability Tester
TF165B
TESTEX Testing Equipment Systems Ltd.
Water Vapour Permeability Tester, also called Water Vapor Transmission Rate Tester (WVTR Tester) is to determine the water vapor permeability of various textile and garment fabrics, coating fabric, composite, sportswear, and industrial fabrics. This tester complies with ASTM E96, GB/T 12704, JIS L1099, etc.
-
product
SparkFun Soil Moisture Sensor
The SparkFun Soil Moisture Sensor is a simple breakout for measuring the moisture in soil and similar materials. The soil moisture sensor is pretty straight forward to use. The two large exposed pads function as probes for the sensor, together acting as a variable resistor. The more water that is in the soil means the better the conductivity between the pads will be and will result in a lower resistance, and a higher SIG out.
-
product
Shallow Water Ice Profiler
The Shallow Water Ice Profiler (SWIP) is a real-time acoustic ice thickness measurement (ice draft) instrument for shallow water applications. The underwater components include a low-cost acoustic transducer, a tilt sensor, a high-precision pressure sensor and a temperature sensor, all providing suitably high resolution for shallow water measurements.
